![]() ![]() Avoid buying any of the products when abroad. ![]() Consult a doctor if you have consumed any of the products and are feeling unwell.Please refer to the pdf document for images of the products. Please refer to Annex A and Annex B for the list of products and the possible side effects of the potent ingredients. ![]() This information is provided to increase awareness on safety issues of such products found overseas, which may impact the local population. ![]() The Health Sciences Authority (HSA) would like to update the public on products that have been found and reported by overseas regulators in March 2023 to contain potent ingredients which are not allowed in these products and may cause side effects. The other problem was not with blendedge, was with BLEND SRF, and again, it works ok but with an extra step into it: it is set to tangent always, but you have to click in “chain edges” for it to assume the tangent edges, otherwise you click the first edge and the next one tangent edge but it assumes as the second surface to blend and starts the blended process immediatly- in Rhino 5 you click the first edge and the next tangent one (without clicking in"chain edges" in the beggining), it is still in the first set of surfaces, doesn´t step right to the second surface.HSA updates on products found overseas that contain potent ingredients (March 2023) In FILLET EDGE everything works and you can add new handles perfecly, the problem is inserting the value of the new handles: in Rhino 5 you click in “add handle” and then type a different value than the original one, enter, and it assumes it but in Rhino 7 you click in “add handle” and then if you type a different number, enter, it goes back to the previous options and leave the add handle section - it only works if you click in “current value” to change, which was not necessary previously… Is an added step not intuitive and no purpose on making it more difficult with and added step… I use a lot this command and it makes a huge difference! Thank you for your reply but you didn´t understand the problem… So, first the EXTEND SRF command doen´t work several times, but just opening the file in Rhino5 and it does work (using the same settings, as Smooth for example and the same amount, say 5) - so it clearly is a bug of Rhino 7, otherwise the same file wouldn´t work in the oprevious version of rhino…Īnother thing that upset me is the FILLET EDGE, don´t even understand why it doesn´t allow me to select the edges sometimes, and again, it does work in rhino 5, something is not right inn there… Aklso in this command, when I want to add a hadle, in Rhino 5 I just type in the new value and it changes instantly, but in rhino 7 I have to click specifically in “current radius” (or C) to chage it! otherwise doesn´t work and is completly not intuitive and a change for the worse, for sure…Īlso the BLEND SRF is worse in my opinion, as unless I click first in “chain edges”, it doesn´t allow me to click in several edges for the first srf to blend, it goes from first to second automatically - please notice that in Rhino 5 if I select and edge not connected at all to the previous one, it will also automatically assume the second set of edges, without have to “enter”, so is much more intuitive! please fix this also… I´ve been using Rhino 7 for about 2 months now and although I´m really happy with the new “quad remesh” and will try subd modelling for sure in the future, I have noticed several things of “normal” old commands that don´t work properly, and I have to open the file in Rhino 5 sometimes to get it done. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |